Certified Pre-Owned Equipment
The Best Used Machines Ever
Our Certified Pre-Owned machines give you piece of mind so you can begin production the moment you receive and install the machine.
“Certified Pre-Owned” by StopolES®
- Horizontal or Vertical
- Trade-ins, demos or repurchases
- Toggle, hydraulic or all-electrics
- Tonnages from 50-2,000
- Performance and productivity at a fraction of the cost
- It’s certified
It all starts with a 42-point inspection:
General Inspection
1 – Machine General Appearance—Note and major defects
2 – Machine nameplate visible
3 – Barrel Cover present
4 – Leveling Pads
5 – Operator Gate function
6 – Non-Op side Gate function
7 – Purge Guard function
8 – Drop Bar Assembly
9 – E-Stop Button & Safety Interlocks
10 – Electrical Cabinet Switches
11 – Electrical Cabinet Modifications—please note
12 – Note any safety components not present or functional Note any repairs made
13 – Manuals and prints
Hydraulic System Inspection
Verify proper hydraulic operating pressures utilizing calibrated pressure gages. Check the hydraulic pressures utilizing the Machine Set Up document (M.S.U.) if available and/or hydraulic diagram.
14 – Clamp Cylinder
15 – Advance Cylinder
16 – Injection Cylinder
17 – Hydraulic Screw Motor
18 – Hydraulic Proportional Valves
19 – Hydraulic Manifolds
20 – All Pumps (fixed, variable volume)
21 – Pipe and hose inspection. Clean and inspect tank, replace filters/strainers
Machine Surfaces
22 – Moving Platen
23 – Stationary Platen
24 – Tie bars
25 – Platen holes checked and retapped/repaired
26 – Bushing and guide integrity
27 – Heat Exchanger. Acid clean and pressure test
Clamp Assembly Inspections
Hydraulic Clamp Machines
28 – Check Ram condition, Ram seals. If central lube system note and if functioning.
Toggle Clamp Machines
29 – Check for bushing wear, toggle integrity. If central lube system, note if functioning.
Injection Unit Inspection
30 – Check Screw RPM
31 – Check Profile for velocity, pack/hold, back pressure, and screw recovery to verify is following trace correctly
32 – Slip check test
33 – Verify all zone heats
Controller
34 – Does controller take inputs and is membrane responsive
35 – All Screens display and readable
36 – Update software as needed
37 – Note hours if available
38 – Machine functions in closed-loop
39 – Note options—hydraulic knockout, corepull, etc.
Runoff and Systems Check
40 – Run in Auto, semi, manual
41 – Extrude plastic
42 – Verify clamp tonnage with mold block
The result is a “Certified Pre-Owned” Machine backed by StopolES®
The machines come with a 90 day run warranty, including parts and workmanship.